AudioCodes MediaPack 114 Instrukcja Użytkownika Pobierz pdf (Strona 299)

Version 5.6 299 November 2008

SIP User's Manual 4. ini File Configuration

Parameter Description

FaxModemBypassM

For a description of this parameter, refer to ''Configuring the Fax /

Modem / CID Settings'' on page 69.

FaxModemNTEMode

Determines whether the device sends RFC 2833 ANS/ANSam

events upon detection of fax and/or modem answer tones (i.e., CED

tone).

 [0] = Disabled (default).

 [1] = Enabled.

Note: This parameter is applicable only when the fax or modem

transport type is set to bypass or Transparent-with-Events.

FaxBypassPayloadType

For a description of this parameter, refer to ''Configuring the RTP /

RTCP Settings'' on page 73.

CallerIDTransportType

For a description of this parameter, refer to ''Configuring the Fax /

Modem / CID Settings'' on page 69.

ModemBypassPayloadType

Modem Bypass dynamic payload type.

The range is 0-127. The default value is 103.

FaxModemRelayVolume

Determines the fax gain control.

The range -18 to -3 corresponds to -18 dBm to -3 dBm in 1-dB steps.

The default is -6 dBm fax gain control.

FaxBypassOutputGain

For a description of this parameter, refer to ''Configuring the Fax /

Modem / CID Settings'' on page 69.

ModemBypassOutputGain

For a description of this parameter, refer to ''Configuring the Fax /

Modem / CID Settings'' on page 69.

T38MaxDatagram

For a description of this parameter, refer to ''Configuring the Fax /

Modem / CID Settings'' on page 69.

T38FaxMaxBufferSize

Defines the maximum size (in bytes) of a T.38 buffer supported by

the device. This value is included in the outgoing SDP when T.38 is

used for fax relay over IP.

The valid range is 100 to 1,024. The default value is 1,024.

DetFaxOnAnswerTone

For a description of this parameter, refer to ''SIP General

Parameters'' on page 101.

NTEMaxDuration

Maximum time for sending Named Telephony Events (NTEs) to the

IP side, regardless of the time range when the TDM signal is

detected.

The range is -1 to 200,000,000 msec (i.e., 55 hours). The default is -

1 (i.e., NTE stops only upon detection of an End event).

EchoCancellerAggressiveN

Enables or disables the Aggressive NLP at the first 0.5 second of the

call. When enabled, the echo is removed only in the first half a

second of the incoming IP signal.

 [0] = Disable (default)

 [1] = Enable

1 2 ... 294 295 296 297 298 299 300 301 302 303 304 ... 389 390

Komentarze do niniejszej Instrukcji

Brak uwag

AudioCodes MediaPack 114 Instrukcja Użytkownika Strona 299

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Bramy / kontrolery AudioCodes MediaPack 114