AudioCodes MediaPack 114 Instrukcja Użytkownika Pobierz pdf (Strona 176)

SIP User's Manual 176 Document #: LTRT-65411

MediaPack Series

3.4.4.6.2 Automatic Dialing

The 'Automatic Dialing' page allows you to define a telephone number that is automatically

dialed when an FXS or FXO port is used (e.g., off-hooked).

Notes:

• After a ring signal is detected on an 'Enabled' FXO port, the device

initiates a call to the destination number without seizing the line. The line

is seized only after the call is answered.

• After a ring signal is detected on a 'Disabled' or 'Hotline' FXO port, the

device seizes the line.

• You can also configure automatic dialing using the ini file table parameter

TargetOfChannel (refer to ''Analog Telephony Parameters'' on page 279).

• You can configure the device to play a Busy/Reorder tone to the Tel side

upon receiving a SIP 4xx, 5xx, or 6xx response from the IP side (i.e., Tel-

to-IP call failure), using the ini file parameter FXOAutoDialPlayBusyTone

(refer to ''SIP Configuration Parameters'' on page 260).

¾ To configure Automatic Dialing, take these 5 steps:

1. Open the 'Automatic Dialing' page (Configuration tab > Protocol Configuration

menu > Endpoint Settings submenu > Automatic Dialing page item).

Figure 3-80: Automatic Dialing Page

2. In the 'Destination Phone Number' field corresponding to a port, enter the telephone

number that you want automatically dialed.

3. From the 'Auto Dial Status' drop-down list, select one of the following:

• Enable [1]: The number in the 'Destination Phone Number' field is automatically

dialed if the phone is off-hooked (for FXS interfaces) or a ring signal (from

PBX/PSTN switch) is generated to a port (FXO interfaces).

• Disable [0]: The automatic dialing feature for the specific port is disabled (i.e., the

number in the 'Destination Phone Number' field is ignored).

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 389 390

Brak uwag

AudioCodes MediaPack 114 Instrukcja Użytkownika Strona 176