AudioCodes Mediant 600 Instrukcja Instalacji Strona 34
- Strona / 52
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Installation Manual 34 Document #: LTRT-85605
Mediant 600
3.1.4 Assigning an IP Address using the CLI
You can assign an IP address to the device, using command-line interface (CLI).
¾ To assign an IP address via the CLI:
1. Connect the device's RS-232 port to either COM1 or COM2 communication port on
your PC (refer to ‘Connecting the RS-232 Port to a PC’ on page 25).
2. Use a serial communication software (e.g., HyperTerminal
TM
) to establish a serial
communication link with the device, using the following communications port settings:
• Baud Rate: 115,200 bps
• Data Bits: 8
• Parity: None
• Stop Bits: 1
• Flow Control: None
The CLI prompt appears.
3. At the prompt, type conf, and then press <Enter>; the configuration folder is
accessed.
4. To view the current network parameters, at the prompt, type GCP IP, and then press
<Enter>; the current network settings are displayed.
5. Change the network settings by typing the following:
SCP IP [ip_address] [subnet_mask] [default_gateway]
For example,
SCP IP 10.13.77.7 255.255.0.0 10.13.0.1
The new settings take effect on-the-fly and connectivity to the device is active at the
new IP address.
Note: This command requires you to enter all three network parameters (each
separated by a space).
6. To save the configuration, at the prompt, type SAR, and then press <Enter>; the device
restarts with the new network settings.
- Installation Manual 1
- Table of Contents 3
- List of Figures 4
- List of Tables 5
- Trademarks 7
- WEEE EU Directive 7
- Customer Support 7
- Related Documentation 8
- Caution Electrical Shock 8
- 1 Introduction 9
- Reader’s Notes 10
- 2 Installing the Device 11
- 2.1.1 Front Panel 12
- 2.1.2 Rear Panel 13
- 2.3 Mounting the Device 14
- 2.3.2 19-Inch Rack Mounting 16
- 2.4 Cabling the Device 17
- Protective Earthing 18
- To connect the E1/T1 trunks: 19
- ¾ To connect the BRI ports: 21
- 3 Configuring the Device 27
- To set a configuration URL: 32
- ¾ To configure the trunks: 38
- 3.7 Upgrading the Device 43
- 4 Monitoring the Device 49
- 4.2 Web Interface 50
Powiązane produkty i podręczniki dla Bramy / kontrolery AudioCodes Mediant 600
(40 strony)HUSQVARNA-ELECTROLUX QFC90351X manuály
Uživatelské manuály a uživatelské příručky pro Odsavače par HUSQVARNA-ELECTROLUX QFC90351X.
Poskytujeme 1 manuály pdf HUSQVARNA-ELECTROLUX QFC90351X ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Komentarze do niniejszej Instrukcji