AudioCodes Mediant 3000 Instrukcja Użytkownika Pobierz pdf (Strona 35)

Microsoft Lync and ThinkTel SIP Trunk 35 June 2012

Microsoft Lync and ThinkTel SIP Trunk 4. Configuring the E-SBC Device

¾ To configure an External SRD:

1. Open the SRD Table page (Configuration > VoIP > Control Network > SRD Table).

2. Add an entry with index 2 to the SRD table. This will represent the SBC’s External

interface (towards the ThinkTel SIP Trunk).

3. Assign a descriptive name to the interface entry (e.g., WanSRD).

4. Enter the 'Media Realm' field value (e.g., WanRealm).

Figure 4-10: External SRD Configuration

5. Click Submit.

4.3.3 Configuring SIP Signaling Interfaces

The SIP Signaling Interface represents a combination of ports (UDP, TCP and TLS)

associated with a specific IP address. It allows other SIP nodes on the network to

communicate with a specific SRD, using the SIP Interface associated with it.

Specify internal and external SIP interfaces for the device:

Figure 11: SIP Interface - Required Configuration

¾ To configure Internal SIP Signaling Interfaces:

1. Open the SIP Interface Table page (Configuration > VoIP > Control Network > SIP

Interface Table).

2. Create a new row; enter 1 and click Add.

3. In the 'Network Interface' field, enter the name Voice.

4. From the 'Application Type' drop-down list, select SBC.

5. Set 'TLS Port' to 5067.

6. Set the 'SRD' field value to 1.

7. Click Apply.

¾ To configure External SIP Signaling Interfaces:

1. Open the SIP Interface Table page (Configuration > VoIP > Control Network > SIP

Interface Table).

2. Create a new row; enter 2 and click Add.

3. In the 'Network Interface' field, enter the name WanSP.

4. From the 'Application Type' drop-down list, select SBC.

5. Verify the 'UDP Port' is 5060.

6. Set the 'SRD' field value to 2.

7. Click Apply.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 62 63

Brak uwag

AudioCodes Mediant 3000 Instrukcja Użytkownika Strona 35